Revolabs Single Channel System - Polycom HDX 9001/9002 Manual de usuario descargar pdf

Revolabs Single Channel System - Polycom HDX 9001/9002 Setup Guide

NOTES AND CA UTIONS:

This setup guide will guide you through the steps needed to properly connect a

Revolabs Single Channel System to a Polycom HDX 9001/9002 v ideo codec.

1. Connecting the Cables

2. Configuring the HDX 9001/9002 Video Codec

Note:

It is important to carefully follow these instructions in order and completely .

Otherwise your Single Channel System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding.

Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Single-Channel System

2. Revolabs 2.5mm to RCA Audio Cable (included with Single -Channel)

3. Polycom HDX 9001/9002 video codec

4. Polycom Audio Adapter Cable (P/N 2457-23492-001) or equivalent*

*POLYCOM HDX 9000 SERIES VIDEO CODEC S HAVE PHOENIX CONNECTORS FOR A UDIO INPUT/OUTPUT WHILE REVOLABS

FUSION PRODUCTS USE RCA CONNECTORS FO R AUDIO INPUT/OUTPUT. THE POLYCOM AUDIO ADAPTER CABLE CONVERTS

TWO PHOENIX CONNECTO RS INTO FEMALE RCA CONNECTORS. OTHERWISE, A TECHNICIA N COULD SIMPLY CUT OFF THE

ENDS OF THE RCA CABLES AND CONNECT PER THE DIAGRAM ON THE FOLLOWING PAGE:

1 2 3 4

Revolabs Single Channel System - Polycom HDX 9001/9002 Setup Guide NOTES AND CA UTIONS: This setup guide will guide you through the steps needed to

Connecting the Cables CONNECTING A REVOLABS SINGLE CHANNEL SYSTEM TO POLYCOM HDX 9001/9002 VIDEO CODEC 1. Connect a Revolabs 2.5mm to RCA audio c

Configuring the HDX 9001/9002 Video Codec CONFIGURING THE AUDIO MENUS OF THE HDX 9001/9002 VIDEO CODEC 1. Select SYSTEM 2. Select ADMIN SETTINGS a

Sin comentarios

Revolabs Single Channel System - Polycom HDX 9001/9002 Manual de usuario